Режущий инструмент2025

HXSQ-100F для шлифов покрытий инструмента

HXSQ-100F прецизионно режет пластины с покрытием TiAlN без сколов; толщина 3,0±0,3 мкм по шлифу, выход годных с 88% до 99%.

Компания
Завод покрытий инструмента, Вост. Китай
Адрес
Чанчжоу, Цзянсу
HXSQ-100F для шлифов покрытий инструмента
3.0±0.3 μmТолщина покрытия
99%Выход годных

TiAlN coating thickness was measured by XRF, whose conversion factors for curved cutting edges drifted with substrate composition - up to 15% off true section values - causing both chipping from over-thick coatings and early wear from thin ones.

Solution: an HXSQ-100F precision cutter with a low-speed diamond blade and automatic feed sections coated inserts without edge chipping or delamination. After hot mounting and polishing to 1 um, coating thickness and interface integrity are read directly at 500X.

Results: measured thickness holds 3.0±0.3 um; grade-specific correction factors from section data brought XRF agreement within 3%. Batch thickness conformance rose from 88% to 99% and chipping complaints dropped 55% quarter on quarter.

⇄0СравнениеСравнение характеристик