Additive manufacturing2025

Microhardness mapping of SLM 316L additive specimens

HVS-1000M micro-Vickers with a motorised stage maps a 20×10 HV0.3 array across SLM 316L sections in 40 minutes, revealing melt-pool boundary hardness swings of 185-215 HV.

Company
An additive manufacturing institute, E. China
Address
Shanghai
Microhardness mapping of SLM 316L additive specimens
40 min200 points in
185~215 HV0.3Hardness range

The institute prints SLM 316L at 99.7% density, but hardness differences between melt-pool boundaries and centres matter for fatigue assessment. Placing 200 indentations by hand took two days, and coordinate records easily slipped.

Solution: an HVS-1000M micro-Vickers hardness tester with a motorised XY stage and automatic measurement software, HV0.3 (2.942 N) load with 10 s dwell. After polishing, the section is indented in a 20×10 array with automatic diagonal reading and hardness contour-map output.

Result: 200 points in 40 minutes, hardness 185-215 HV0.3, and the map clearly shows an about 80 µm softening band in the overlap zone; repeat positioning accuracy is ±2 µm.

Benefit: the mapping data drove parameter optimisation, and after hatch-spacing adjustment cross-section hardness uniformity improved by 8%.

⇄0CompareProduct comparison