The plant requires coplanarity within 0.08 mm on 32-pin connectors. A profile projector needed six minutes per part, and with chamfered tips the visual judgement was unstable, so returns concentrated on coplanarity.
Solution: YRVMS2515F with 0.7–4.5× bi-telecentric optics to remove perspective error and a programmable ring light at low angle to graze the tip contour. The coordinate system is built on the two locating posts, the 32 tips are fitted to a common datum plane, and the software reports coplanarity plus per-pin deviation.
Result: 25 seconds per part with repeatability within 3 µm; trend charts showed cavity 3 of the mould running 0.02 mm low, and after repair CPK rose from 0.9 to 1.5 with returns down 85%.




