Connectors2025

Coplanarity of 32 automotive connector terminals in a single pass

YRVMS2515F with bi-telecentric optics and programmable ring light measures all 32 terminals in 25 seconds with repeatability within 3 µm, replacing one-by-one projector checks.

Công ty
Automotive connector maker, Jiangsu
Địa chỉ
Suzhou, Jiangsu
Danh mục
Máy đo ảnh
Coplanarity of 32 automotive connector terminals in a single pass
6 min → 25 sPer part
≤3 μmRepeatability
0.9 → 1.5CPK

The plant requires coplanarity within 0.08 mm on 32-pin connectors. A profile projector needed six minutes per part, and with chamfered tips the visual judgement was unstable, so returns concentrated on coplanarity.

Solution: YRVMS2515F with 0.7–4.5× bi-telecentric optics to remove perspective error and a programmable ring light at low angle to graze the tip contour. The coordinate system is built on the two locating posts, the 32 tips are fitted to a common datum plane, and the software reports coplanarity plus per-pin deviation.

Result: 25 seconds per part with repeatability within 3 µm; trend charts showed cavity 3 of the mould running 0.02 mm low, and after repair CPK rose from 0.9 to 1.5 with returns down 85%.

⇄0So sánhSo sánh thông số