HVOF WC-Co coatings are 200–400 µm thick and the edges round easily during thickness and porosity measurement. Conventional hot mounting and manual polishing produced rounded edges, thickness reading 10% low and porosity polished away.
Solution: HXQ-50 low-speed sectioning at 180 rpm with a diamond wheel, vacuum mounting of sample plus support plate in epoxy at -0.09 MPa (HXZDQ-100Z), stepped grinding and polishing, then 15 seconds of electrolytic polishing to remove the deformed layer.
Result: thickness deviation down from 12% to 2% with straight edges, and three-operator agreement on porosity from 70% to 95%; the method is now used in the company coating qualification.




