Штамповая отрасль2024

HXZDQ-120 для резки азотированных образцов H13

HXZDQ-120 с водяным охлаждением режет азотированные образцы H13 со слоем прижога до 3 мкм; белый слой 8 мкм и зона диффузии 0,15 мм измеряются без искажений.

Компания
Термический цех пресс-форм, Юж. Китай
Адрес
Фошань, Гуандун
HXZDQ-120 для резки азотированных образцов H13
≤3 μmСлой прижога
8 μmБелый слой

After gas nitriding of H13 die-casting dies, white layer and diffusion zone depths must be measured. Aggressive abrasive cutting left a 20 um burn layer that etched away the white layer, so it was misread as having no compound layer and qualification took three rounds.

Solution: an HXZDQ-120 metallographic cutter with water cooling and a low 0.05 mm/s feed keeps the burn layer within 3 um. Edge-protecting hot mounts are polished to 1 um and etched in 4% nital, then white layer and diffusion depths are read at 500X.

Results: the 8 um white layer and 0.15 mm diffusion zone measure cleanly, agreeing with HV0.3 microhardness gradient mapping. Nitriding qualification fell from three rounds to one, early soldering on dies dropped 40%, and trial cost per die fell by 18000 yuan.

⇄0СравнениеСравнение характеристик