Bài kỹ thuật126 lượt xem

Máy đo độ cứng siêu âm UCI: nguyên lý và kinh nghiệm sử dụng

UCI đo dịch tần số cộng hưởng của thanh có kim cương Vickers; vết ấn gần như không nhìn thấy.

华旋光电技术部
Máy đo độ cứng siêu âm UCI: nguyên lý và kinh nghiệm sử dụng

UCI principle

UCI, ultrasonic contact impedance per ASTM A1038, presses a resonating rod tipped with a 136-degree Vickers diamond against the specimen. Under the test load the diamond forms a contact area A that shifts the resonance frequency by Δf, monotonically related to A, from which the Vickers value is computed. Loads run from 1 to 98 N in steps, and the measured quantity is dynamic contact behavior, so the diagonal stays below about 20 μm — invisible to the eye, hence the name non-destructive hardness.

Applicability boundaries

  • Specimen mass of at least 0.3 kg and thickness of at least 3 mm (lower loads relax this); couple to a rigid base otherwise;
  • Surface roughness Ra of 3.2 μm or finer, since rough surfaces destabilize contact; curvature radius down to 5 mm works, smaller needs special anvils;
  • Material must match the calibration family: instruments ship calibrated for steel, copper and aluminium need correction factors or custom curves;
  • Coatings need at least 30 μm thickness at HV settings, otherwise the substrate interferes.

Field practice

Hold the probe perpendicular; use a guide sleeve for handheld work — a 2-degree tilt already introduces more than 3 percent error. Each reading takes about two seconds; repeat three times per point and discard outliers. Probe wear causes slow drift: a chipped diamond pyramid pushes readings systematically high, so verify daily against a reference block and send for repair beyond ±4 percent deviation.

Comparison with bench testing

Agreement between UCI and bench HV on well-prepared surfaces of the same material family stays within ±3-5 percent, roughly ±20-30 HV. UCI complements rather than replaces bench testers: in-service checks on large parts, quick confirmation at the heat-treatment furnace, 100 percent sampling of coated products. Acceptance and arbitration still belong to bench Vickers per GB/T 4340; UCI reports should state the load step, probe model and reference-block batch.

⇄0So sánhSo sánh thông số