Reading Ra, Rz and Rt: Why One Surface Gives Three Different Numbers
Ra is the arithmetic mean, Rz the ten-point height, Rt the total peak-to-valley; on one surface they can differ 5-10×, so measure what the drawing says.

Definitions
Within the sampling length, under the GB/T 1031 system corresponding to ISO 4287: Ra is the arithmetic mean of absolute profile deviations, the average processing quality; Rz, the ten-point height, averages the five highest peaks and five deepest valleys, more sensitive to local extremes; Rt is the total peak-to-valley height over the evaluation length, including accidental scratches. On one fine-ground surface typical values read Ra 0.4 μm, Rz 3 μm, Rt 5 μm — a 5-10 fold spread is perfectly normal.
Where each applies
Ra is statistically stable and the default for machined surfaces; over 90 percent of drawings specify it. Rz matters more for sealing faces and pre-coating surfaces — sealing fails at the few highest peaks — and European drawings traditionally prefer it. Rt, hostage to extreme values and poorly repeatable, suits only qualitative defect screening, not acceptance. Beware that Rz had two definitions historically; state the standard revision in reports.
Matching measurement settings
Parameters come with matching sampling lengths: Ra 0.4 μm pairs with a 0.8 mm cutoff and 4 mm evaluation length (five sampling lengths); Ra 3.2 μm pairs with 2.5 mm. Instruments auto-select per GB/T 1031 tables, but unusual textures need manual verification. Skidded instruments measure roughness after form removal; precision flats deserve skidless sensors with a datum guide.
Drawing and acceptance advice
GB/T 131 sets Ra as the default parameter with the upper-limit rule, 16 percent of readings may exceed. Supplier and customer should agree on the parameter (Ra or Rz), the limit rule (max marking means no single exceedance), the sampling length and the lay direction. Treating Ra 0.8 as Rz 0.8 at acceptance is the classic export-order failure — the two differ by roughly four to six times.



