Technik679 views

Choosing Heater Elements for Hot Hardness Testers: MoSi₂ vs Graphite

MoSi₂ works in oxidizing atmospheres up to 1700 °C; graphite exceeds 2000 °C but demands vacuum or inert gas. Their electrical behavior and maintenance differ greatly.

华旋光电技术部
Choosing Heater Elements for Hot Hardness Testers: MoSi₂ vs Graphite

Temperature range and atmosphere

MoSi₂ (molybdenum disilicide) elements rely on a self-healing SiO₂ film and can run in air or other oxidizing atmospheres up to 1700 °C, with a maximum surface temperature around 1800 °C. Graphite elements have a far higher melting point and can exceed 2000 °C, but they oxidize rapidly above 600 °C, so they must work in a vacuum of 10⁻² Pa or better, or in high-purity argon or nitrogen. The first selection rule is target temperature plus specimen material: titanium alloys and refractory metals demand an oxygen-free environment anyway, so a graphite furnace is natural; for routine hot hardness work on structural steels and nickel alloys below 1200 °C, MoSi₂ is far easier to live with.

Electrical and structural differences

ItemMoSi₂Graphite
ResistivityHigh, nearly constant with temperature, rises with ageingLow, needs low voltage and high current
Power supplyOrdinary variable transformerHigh-current transformer, water-cooled electrodes
ReplacementSingle elements can be swapped hotUsually whole set, breaking vacuum
Typical lifeThousands of hours in air at 1600 °C1-2 years in vacuum, depending on sublimation and damage

Impact on measurement

Graphite furnaces raise a carbon potential issue: at high temperature the carbon vapor pressure contaminates active metals such as titanium and niobium, forming a carburized skin that inflates hardness by 3 to 8 percent; wrapping the specimen in molybdenum foil is a practical countermeasure. MoSi₂ elements suffer pesting disintegration between 400 and 700 °C, so heat quickly through that window and avoid long holds there. For both furnace types the uniform zone should hold ±3 °C over a 50 mm working length; verify the thermocouples periodically per JJG 351 using sheathed reference couples.

Maintenance notes

MoSi₂ rods are brittle: leave thermal expansion clearance at installation and do not overtighten the clamps. On a new furnace, hold at 1200 °C for one hour to grow the protective film. Graphite parts dislike thermal shock; after shutdown keep vacuum or backfill argon and vent only below 200 °C. These two habits noticeably extend element life and keep temperature uniformity inside specification.

⇄0VergleichTechnischer Vergleich