Четыре метода оценки круглости: минимальная зона и наименьшие квадраты
Одно сечение — четыре опорные окружности; минимальная зона даёт наименьшее значение и служит арбитражем.

Four reference circles
Roundness is the departure of a real profile from an ideal circle, per GB/T 7235 corresponding to ISO 12181, and evaluation hinges on the reference circle: minimum zone (MZC) uses two concentric circles of minimum radial separation containing the profile; least squares (LSC) minimizes the sum of squared residuals; maximum inscribed (MIC) and minimum circumscribed (MCC) circles serve the assembly view of holes and shafts. On one section, MZC ≤ LSC ≈ MIC ≈ MCC, with LSC typically 10-30 percent larger than MZC.
Standards and selection
GB/T 7235 defines minimum zone as the reference, mandatory for arbitration. LSC is computationally stable, insensitive to single burr points, and the practical default of instruments and daily inspection. MIC/MCC assess fit: hole parts care about MIC, shafts about MCC. When the drawing is silent, MZC applies; an LSC result is conservative and uncontroversial when it passes — the reverse inference needs a recalculation.
Filtering and probe effects
Roundness data are filtered: 15, 50, 150, 500 undulations per revolution, lower settings removing more harmonics. Bearing rings use 500 upr to keep lobing detail; large shafts are fine at 50 upr. Stylus radius and force shape the high-frequency content: a standard 2 μm tip at about 0.75 mN; reduce force on soft materials like aluminium to avoid indenting. The spindle is the soul of a roundness tester, with precision spindles below 0.02 μm error, verified periodically with a reference hemisphere.
Setup essentials
Centering and levelling dominate the error budget: eccentricity e injects an elliptical artifact of order e²/2R, so center below 10 μm before measuring; tilt adds its own error, level until axial runout is under 1 μm. State the section position in the report, and evaluate each functional section of a stepped shaft separately. When roundness fails with a strong second harmonic, suspect clamping distortion first — parts springing back after release from a three-jaw chuck are a classic case.



